help me publish good upgrade plans
David B. Thomas
dt at yenta.alb.nm.us
Fri Jun 14 15:48:27 AEST 1991
As I have announced, I am putting together a comprehensive set of ascii files
containing the plans for my "piggyback" on-the-motherboard second hard disk
upgrade. Even the schematic is all in ascii (not bad, if I do say so myself!)
Anyway, I want my plans to be as informative as possible, so someone
contemplating the procedure won't have to dig all around for various
tidbits of info.
Here's some things I don't know but that I want to include. Please help!
1. Where can good power supplies be found (for spinning up two hard drives)?
PeeCee supplies tend to be heavy on the +5 and light on the +12, which is
exactly the opposite of what is required here. I wound up using a HUGE
PeeCee type supply (5A line fuse!), but I'm sure one could do better. (?)
2. Where can handy external hard disk enclosures be found? What works for
this? Are there any that come complete with power supply? Are there
standard connectors on the backs of these, that it might be a good idea
to conform to?
3. I can find the fountain of youth. I can find the holy grail. But what
continues to elude me is a 20-pin male DIP plug that crimps-on
(insulation displacement) to ribbon cable. I've seen them in 14- and
16-pin, but never 20. The (very rare) 20-pin DIP plugs I have seen
have solder terminals. Booo. This would *really* be useful for my
upgrade. I had to do extra work because I couldn't find one. Does
it exist?
4. What can I tell my readers of the HD2 upgrade? I try to describe all
upgrade paths, stating the advantages and disadvantages of each as
fully and honestly as I can. In particular, (a) does it do P5.1,
(b) is a four-hard-disk version of the 3.51m kernel available,
(c) what is still available from John and what does it cost?
Also, while I have you all here :^) Suppose you are contemplating a two-disk
upgrade, and I suggest that you put both hard disks in an external case
because (a) it eases the load on the overworked 3b1 supply, (b) you'll need
and external case and power supply for the second hard drive anyway, and
(c) you won't need to open the 3b1 in the future if you need to switch your
hard drives around. Would you still decide to leave the internal drive
inside, would you follow my suggestion, or would you do something else
entirely?
The reason I ask is that I want to go into the most detail describing the
procedures that most people will follow, and mention more briefly the
alternatives. I do describe every configuration I know of, including
both-internal-with-two-floppies-external (hi, Dave B!), both-internal-stacked
(hi, Craig V!), one-in-one-out (hi, Gil&Lenny!) and both-external (hi,
myself!). So, consider this an informal survey. You determine the
nature of the document!
--
Unix is not your mother.
More information about the Comp.sys.3b1
mailing list