failing memory in AT&T 6300's
Michael R. Volow
mvolo at ecsvax.uncecs.edu
Sun Nov 13 05:27:17 AEST 1988
In article <61050O05 at PSUVM>, O05 at PSUVM.BITNET writes:
> I have a lab of 20 AT&T PC6300's. They have been doing fine, and just
> two weeks ago, I started having problems with memory. Little to my
> liking, the chips are soldered on a memory expansion board. Why AT&T
> chose this route, I'll never know, but that doesn't matter.
>
> Does anyone out there know what might cause 4 machines to develop the same
> memory symptoms at the same time. To the best of my knowledge, no spikes,
> surges, etc have gone through the room. It seems to be located in the bank
> between 256 and 384k which would make it the first bank on the memory
> expansion card after the 256 on the motherboard.
>
> (215) 320-4819
Not sure it this is an answer to you problem, but here goes. I had
a direct lightning hit on my house, entering the house wiring and the
phone lines both. The surge appeared to enter my computer (had surge
protector) through the phone line --> modem --> serial port --> bus!!
Needless to say everything closest to the bus was zapped (modem, com1,
parallel port, accessory switch on monitor, printer interface chips..
.....). I wonder if something like this happened to your AT&T's.
Were the four computers with memory damage near each other on the cir-
cuit? It sounds like the damaged chips were those closest to the bus.
I/O lines are royal roads into the guts of the computer and are most
often totally unprotected from surges (unless you have a modem surge
protector). Don't know whether this applies to your situation or
not.
M Volow, VA Medical Center, Durham, NC mvolo at ecsvax
More information about the Comp.sys.att
mailing list