cu on a 3b1 is SLOW
root at spdyne.UUCP
root at spdyne.UUCP
Wed Aug 2 01:30:23 AEST 1989
In article <18818 at mimsy.UUCP>, steveg at tove.umd.edu (Steve Green) writes:
>
> I am a new unixpc user, but it seems that when I do a cu to another unix
> machine at 9600 baud (a Mac II) it moves like molasses.
Written by stevens at hsi.UUCP
> The first problem is that cu does a read() system call of 1 byte from
> the communications line, followed by a write() of 1 byte to the standard
I don't think that this is the major problem.....
> The second problem is that the 3b1 console can't run at 9600.
> Cat a big file to the screen and time it - it's about 5500 baud max.
Which is not all that bad, considering it's running in Graphics
mode! On a PC all you have to do is to put 1 byte in 1 location in memory.
On the 7300, I belive you would have to update at least 14 bytes. This would
make it about 14 times slower. (Assuming a 14x8 char set, But I think that
it is a 14x9, thus one would have to *modify* (read then write) 28 bytes.
As well as do a bunch of And's & Xor's.. ) This could make it about
about 60 times slower -- Just because it's in graphics mode... The
Mac had the same problem when it first came out.. (as I recall..)
And scrolling you have to move the entire graphics image.
Chert Pellett
root at spdyne
PS: I'm not knocking the 7300/3b1... I like being in Graphics mode... I
was raised on PLATO.... (And GIGI's on VMS...)
More information about the Comp.sys.att
mailing list