graphics on a Star Gemini 15-X printer from a 3b1
Lenny Tropiano
lenny at icus.islp.ny.us
Mon Jun 26 09:25:50 AEST 1989
In article <494 at ntvax.UUCP> canoaf at ntvax.UUCP (Augustine Cano) writes:
|>I'm using a Star Micronics Gemini 15-X printer with my 3b1.
|>It works fine for normal printing, but being a non-supported printer,
|>I can't do anything fancy. I have the system set up so it thinks it is a
|>StarSG10....
|>
|>If I do a <SHIFT> <PRINT> the screen gets actually printed, but in stripes.
|>The printer does not seem to understand the codes sent to move the paper up
|>less than the usual amount.
|>
Probably the easiest thing to do, if the Star Gemini 15-X is like my Star NX10,
is to set your printer up as an "Epson" printer. The Star NX10 by default
I believe is Epson compatible, you need to change a dip switch to enable
"Star" mode. Probably best if left as Epson, since almost everything has
an Epson driver (including the screen dump) ...
-Lenny
--
Lenny Tropiano ICUS Software Systems [w] +1 (516) 589-7930
lenny at icus.islp.ny.us Telex; 154232428 ICUS [h] +1 (516) 968-8576
{ames,talcott,decuac,hombre,pacbell,sbcs}!icus!lenny attmail!icus!lenny
ICUS Software Systems -- PO Box 1; Islip Terrace, NY 11752
More information about the Comp.sys.att
mailing list