3B2 600 UUCP VIA DATAKIT
Art Gentry
gentry at kcdev.UUCP
Fri May 5 01:08:06 AEST 1989
In article <7996 at killer.Dallas.TX.US>, jccc at killer.Dallas.TX.US (Juan Castillo) writes:
> We need info on how to get UUCP to work through DATA-KIT.
Not much to go on, but hopefully this is what you need:
In DataKit[tm] get into the cimmand mode {datakitcm}
Set the following options on the port you want to do uucp on:
set dkfc none <---turns off flow control
set fc none <--- " " " "
set attn ~ <---sets attention character to tilda
Make sure you do the above on the endpoints for both computers.
Hope this helps, you didn't give us much info on your end to go on.
Art
opinions my own and so on....
More information about the Comp.sys.att
mailing list