Pin settings for StarLAN 10MB hub

[Carlo Milono]

In article <1991Apr19.041855.17030 at fcom.cc.utah.edu> cryptkpr at cc.utah.edu writes:
>I have a 10MB StarLAN hub which I am using with TCP/IP.  I want to hook
>up some Emulex terminal servers onto the net but I have a problem--I need
>to know what the four active pins (out of the eight) on each port of the hub 
>do.  All the manual on the hub says is that two are input and two are output.
>
>I have to build an adapter which will go on the back of the terminal server
>using its active pins to channel the server signals to the hub.  Any help
>sent via e-mail would be appreciated.
Hie thee to comp.dcom.lans for an extended discussion of 10BASE-T!

Actually, you do NOT want to build an adapter as you will be searching
far and wide for electronic components!  If your terminal server is 
10BASE-T compliant (very doubtful), then you just plug an 8-conductor
cord from the hub to the jack on the terminal server.  Since (I'd bet)
the TS is a 'classic' AUI port, you will need to translate the 10BASE-T
signals into those compatible with the AUI port...terribly complex for
a beginner.  Instead...get an AUI adapter from AT&T or a reseller and
look at the spec for your TS to determine the state of Signal Quality
Error (SQE) and set the AUI adapter to match...and you will have saved
yourself the money and time.

-- 
+--------------------------------------------------------------------------+
|  Carlo Milono:  cmilono at netcom.apple.com   or   apple!netcom!cmilono     |
|"When a true genius appears in the world, you may know him by this sign,  |
|that the dunces are all in confederacy against him."   - Jonathan Swift   |
+--------------------------------------------------------------------------+