f77 performance under 3.3.1

[Bron Campbell Nelson]

In article <90Oct29.145239est.57616 at ugw.utcs.utoronto.ca>, WJP at VM.NRC.CA (Wayne Podaima) writes:
> 
> We have some unhappy observations re performance of Fortran programs under
> IRIX 3.3.1.  The same program compiled under 3.3.1 runs about 5% slower
> than it did under 3.2.3 (same compiler options), using 1 cpu of a 4D/240S.
> The program is compute intensive - no paging, no disk I/O, double precision.
> Any ideas; anyone with similar results?
> 
> We then tried the libfpe.a floating point exception handling library,
> expecting it to be still slower; well it ran 2% FASTER than the original
> 3.2.3 compiled version.  What gives?
> 

I don't know about the first part, but I can comment on the second:
in all likelyhood your program is getting a number of underflow exceptions
(IEEE denormalized numbers).  Denorms are *not* handled by the f.p.
hardware, instead they are punted to an exception handler (which does the
f.p. operation in software).  In libfpe.a on the other hand, the default
setting for underflow is to flush the value to zero, rather than to compute
the denorm.  Note that this setting is *not* IEEE compliant.  The advantage
is that zero is a value that the hardware can handle.  You still take an
exception when the value is first computed, but by flushing it to zero,
you do not take further exceptions when that value is subsequently used.

(Hummm ... I see someone might read that wrong .. the f.p. underflow
"exception" is *not* an error, it is just an exceptional (unusual)
event.  Therefore it is dealt with by an exception handler, rather
than by throwing hardware at the problem.)

The numbers you report above seem to indicate you were spending 10%+ of
your time dealing with denorm values, so you must have been getting a
*lot* of them.


--
Bron Campbell Nelson
bron at sgi.com  or possibly  ..!ames!sgi!bron
These statements are my own, not those of Silicon Graphics.