Sunlink X.25 [help]
Eric Ho
eric at picard.sbi.com
Wed Feb 20 06:22:00 AEST 1991
Has anyone out there tried using Sunlink X.25 over a pair of synchronous
Codex modems before (both at 9.6k baud). The line is not dedicated --
just local phone calls -- actually the modems are only 2 buildings apart.
However, one Codex is hooked to a Tandem while the other one is hooked to
a Sun-4/260 under SunOS 4.1.
The SunLink X.25 setup is pretty much generic except that I'm not running
x25manager since I'm not configuring the Sun-4 to be an internetwork
router. So, upon reboot, it simply run x25start, x25config and x29.
Is there anyway I can test if my setup at the Sun-4's end is ok -- I tried
'vcstat 0' but it said hdlc down and packet level down.
Do I need to reconfig the serial ports differently ? The codex modem just
hooked to ttya on the Sun-4/260 -- nothing has been changed to ttya
however. I'm pretty sure however that the modems are connected - the LEDs
on both modems said "Data Ready 9600 Restr" and the TxD and RxD lights on
both modems are lit. The Codex on the Sun-4 end is accepting calls while
the Codex on the Tandem end is initiating calls.
Can someone enlighten me on this ?
+ Eric Ho Email: eric at sbi.com
+ Salomon Brothers, Inc. [SISS] Phone: (212) 855-3003
More information about the Comp.sys.sun
mailing list