Not-Ready LP hangs system on Sys V/AT

[John Gayman]

     Has anyone else had the experience where queueing up a print job
when the printer is not-ready will hang the system after a few seconds ?
I ran into this for the first time today. Im running Sys V/AT 2.3U.
The printer is turned off, a user types "lp filename" and the job is
queued. Everything is fine for a few seconds and then the system slowly
starts to die. No errors, just cursor disappearing, serial ports stop,
etc. Luckily I was here and just happened to turn the printer on. 
Instantly the system freed up and everything proceeded normally, and
the job printed out.

     Is this normal ?  If so, are there any configuration steps that I
can take to minimize the effects ?  I'm suprized I never ran into it
before.  Thanks.


					John


-- 
John Gayman, WA3WBU              |           UUCP: uunet!wa3wbu!john
1869 Valley Rd.                  |           ARPA: john at wa3wbu.uu.net 
Marysville, PA 17053             |           Packet: WA3WBU @ AK3P