SysV/386: db module not cofigured ???

[Doug Blair]

In article <26061 at ucbvax.BERKELEY.EDU>, carvalho at ernie.Berkeley.EDU (Marcio de Carvalho) writes:
> 
> 	At some apparently random accasions, my Everex 386/20
> running uport's V/386 version 2.2 enters in a loop and fills
> screens and more screens with:
> 
> *** Attention: attempting to run DEBUGGER with no db module configured
> 
> 	And the only way I found to get out of this is to turn 
> the machine OFF and reboot it.

We have also experienced a similar problem, in fact the ONLY problem
that we've had with microport SysV/386.  Our machine has on a couple
of occasions generated the same message when we have attempted to
cu -l ttyXX at the same time that another process is using another
one of the tty's for routine communications.  This happened in the
course of installing a new internal modem card; the card was being
removed and reconfigured (different interrupts and addresses, etc)
and reinstalled a few times.

I suspect we may have a bug related to the AT buss's inability to
have two boards with the same IRQ even throught the devices
don't have the same port address.

Comments, uport?

Thanks
Doug
 ___  _           _  _             _    
|   || |_  ___  _| ||_| ___  __  _| |_  Doug Blair    Obedient Software Corp.
| | ||  .\/ ._\/.  || |/ ._\|  \|_   _| 1007 Naperville Road1 +1 312-653-5527
|___||___/\___/\___||_|\___/|_|_| |_|   Wheaton, Illinois 60187 obdient!blair