Memory expansion problems

[Otto J. Makela]

I use a Unisys 800 (same as the Acer 1100) 20MHz 386 PC/AT clone under
MicroPort UNIX/386 3.0U3.0e; the system has 4992k of 80ns memory (640k+
256k on motherboard + 4096k on a 32-bit expansion board).

I installed an extra 4096k piggyback card onto the expansion board to get
to a total of 9088k memory.  I set the DIP switches, plugged the card in,
powered up the machine and used the BIOS ROM setup to change the CMOS
count of memory above 1M.
I booted DOS and ran the machine's diagnostics on the memory board, and
it checked out as OK (the test did only take about an hour, though...)

Then I tried booting the Unix from the ESDI hard disk.  Right after it had
said "Ram disk 0 found.  size=32Kb" (what the s**t is this, by the way?
I've seen it being used at system build time, but for nothing else...)
it went into an endless loop of:
	"Could not allocate memory for default 0 buffers"...
(the next thing I normally see is "buffers=1400k" or something like that).

Does anyone know what's happening here?  Is the weirding module incorrectly
tuned or what?

Otto J. Makela (with poetic license to kill), University of Jyvaskyla

InterNet: makela at tukki.jyu.fi, BitNet: MAKELA_OTTO_ at FINJYU.BITNET
BBS: +358 41 211 562 (V.22bis/V.22/V.21, 24h/d), Phone: +358 41 613 847
Mail: Kauppakatu 1 B 18, SF-40100 Jyvaskyla, Finland, EUROPE