Using internal modem cards with SCO Xenix

[Tim Kuehn]

In article <958 at lakesys.UUCP> davek at lakesys.lakesys.com (Dave Kraft) writes:
>Hi,
>Where I work, we've got two internal modems (can't remember make offhand),
>configured as MS-DOS's COM3: and COM4:, but, when Xenix is started up, they
>aren't listed on the first screen where it lists what you have in your system.
>I can mkdev serial them allright, but when I try to access them with cu,
>it comes back with an error messge like "cannot acces", or something...
>what's wrong here??

I've got the same problem with a Telebit Trailblazer/+ in a 286 Xenix.
It worked fine installed as COM2:, but no response as COM3:. Any 
suggestions?

+-----------------------------------------------------------------------------+
|Timothy D. Kuehn	       			       timk at xenitec	      |
|TDK Consulting Services			       !watmath!xenitec!timk  |
|871 Victoria St. North, Suite 217A					      |
|Kitchener, Ontario, Canada N2B 3S4 		       (519)-741-3623 	      |
|DOS/Xenix - SW/HW. uC, uP, DBMS. 		       Satisfaction Gauranteed|
+-----------------------------------------------------------------------------+