Adaptec 232XD controller & Maxtor 150MB & ISC2.02

[Bruce M Ong]

I just received an Adaptec 232XD controller - which, according to adaptec,
replaces the old 2322 controller just fine. However, when I tried to
install the ISC2.02 on it, when it was trying to write the partition
table, the install process says
/dev/rdsk/0p0 - device or address not found.

With my old 2322 controller card, I could install unix without any problems,
but with the new controller, I dont seem to be able to pass the partition
table stage.

Does anybody else have the same problem? The drive is an ESDI maxtor 4007.

-thanks,

bruce
deadhead at cup.portal.com