ISC X11 1.2, Logitech serial mouse, FAS 2.08 combo?

[Keith Cantrell]

In article <TQORKNQ at geminix.in-berlin.de> gemini at geminix.in-berlin.de (Uwe Doering) writes:
>ckp at grebyn.com (Checkpoint Technologies) writes:
>
>>I'm sure I've seen the topic arise before, but it's been a while, and
>>I wasn't concerned about the answer at the time so I didn't pay
>>attention...   However, I'm now trying to get the Logitech serial mouse
>>working through FAS 2.08 for ISC X11R3 1.2.  Oh, and yes I have
>>NS16550A's in there.  Thanks.
>
>Switch your mouse to Mouse Systems mode and tell your programs that
>you have a Mouse Systems mouse. That should work.
>
>BTW, I still don't know what special tricks the Logitech mouse driver
>is doing that don't work with FAS. If anyone found out what's going
>on I'd like to hear about it.
>

Hmm, I never tried that, but I can tell you when I first went to version 1.2
from version 1.0 and had FAS 2.08 driving my mouse it would lock up the
display where the only recovery was to push the BIG RED BUTTON.  Things seem
to work fine with just allowing the standard asy driver drive the mouse.
But of course there is nothing that will drive my Telebit like FAS will. :-)

Please let me know if there is a way to allow FAS to drive a Logitech mouse
model # CC-93-9F so I can get rid of the asy driver once and for all.

Type at you later,

Keith

-----------------------------------------------------------------------
Keith Cantrell                    Phones:  hm: 214-492-1088
                                           wk: 214-699-2509 
USMAIL:                          EMAIL:
2100 Sonata Ln                   keith at dinosaur.lonestar.org
Carrollton TX 75007                           or
                                ...!uunet!digi!dinosaur!keith
-----------------------------------------------------------------------