Hitachi DK514C harddisk 330 Mb

[Fred Chappin]

Hello, 

I'm trying to install a hitachi dk514c scsi harddisk on my 386 pc, running
Interactive 2.0.2.
Problem: I'm currently ussing a seagate 80 mb harddisk running interactive
with no problems. The moment i try to install (from scratch) my interactive 
on the hitachi harddisk i get the problem that the installation procedure 
can't open /dev/rdsk/0p0. In both situations the harddisk is configured at 
Target 0 Lun 0, my scsi board from adaptec is configured according the 
defaults (interupt 11, parity enabled, scsi address 7, dma 5). 
Both disks run perfectly under dos (3.1). Both disks are recognized by
the scsi controller when running the format uttility in the adaptec bios.
I tried to use my seagte at target 0 lun 0 and the hitachi at target 1 lun 0
with no results. (1s0 can't be opend). The only way i can use my harddisk
at this moment is when i configure both my scsi board and my hitachi at 
target 0 lun 0. My adaptec bios finds a C and D disk installed. ( D disk 
is not present!). Now interactive can be installed. 
In this configuration i can't use any other scsi devices because all
targets (0 to 7) are used by the hitachi disk. (this is shown by the 
adaptec bios utility). Is there anybody who can give me a hint to 
solve this problem. (Is it hardware or a driver problem ?)

Greetings Fred.

---------------------------------------------------------------------------
-   Fred Chappin             |                                            |
-   Tuinbouwlaan 1-17        |                                            |
-   4817 LE Breda            |                                            |
-   The Netherlands          |                                            |
-   Tel: 076-215200 (voice)  |                                            |
---------------------------------------------------------------------------