AT&T SysV Rel 4.0 - Cry for installation help...
john.urban
urban at cbnewsl.att.com
Fri May 17 02:22:24 AEST 1991
In article <6Pqw21w164w at gantz.bowlgreen.oh.us> gantzm at gantz.bowlgreen.oh.us (gantzm) writes:
>Ok here's the situation:
> ALR Business VEISA 486/33
> 17 Mega Bytes Memory
> Western Digital MFM controller
> 40 Mb Hard Disk 0
> 32 Mb Hard Disk 1
> Monochrome display and card
> Archive VP402 Adapter Card
> Archive 60 Mb Tape Drive / Model 2060L???
> Nothing else, all serial/par ports taken out.
>
> Software:
> AT&T Unix System V Rel 4.0 (Ver 2.1)
> Cartridge Tape Boot Version (2 boot disk/tape, etc)
>
>Problem:
> System boots from boot disks and prepares hard disk fine.
>System then reboots off of the hard disks. System asks if I want
>to install from Tape or Floppy disk, I answer Tape bacause thats
>all I have. Well after that, the tape light comes on, nothing happens
>, and the system then tells me to check my tape drive....
>
> Has anyone gotten AT&T SysV Rel 4.0 to load off of an Archive
>tape drive????? I followed the settings in the book (IRQ=5, DMA=1,
>port = 288) and it doesn't work. I talked to Archive and they said
>to try port = 300, well on the address the tape light does not even
>come on. The Unix guru at Archive is out of the country till June.
>
Not to cop out or coin a phase but ... "AT&T UNIX is only supported on AT&T
Hardware platforms". I know this is a cop out but at least AT&T verifies
that all configurations of its hardware work together with it's software.
AT&T UNIX System V/x86 Release 4.0 Version 2.1 supports: 386, 486, ISA and EISA.
I see you have alot of plug in cards on your box. Are any of these cards (besides
the Tape Drive) set at IRQ 5 DMA=1 I/O 288 -> 289?
The Archive Tape Drive is not really the one supported by AT&T. I belive USL
supports it however.
If you could get a Wangtek Tape Drive and Controller that should work fine.
Sincerely,
John Ben Urban
More information about the Comp.unix.sysv386
mailing list