How to configure additional swap space! (revisited)
Joe Bush
bush at evax.arl.utexas.edu
Wed May 30 14:19:21 AEST 1990
In the hope that other novices might find this useful and the
more experienced Ultrix wizards won't find this too insulting, I would
like to summarize the method I used to successfully configure secondary
swap space.
On a uVAX 3900 w/32Mb of core running Ultrix 3.1 with primary
swap on ra0, and adding "two" secondary swap partitions, each on a
separate drive (ra1 and ra2 in this case), the following procedure
worked well:
1. add the following lines to /etc/fstab
/dev/ra1b::sw:0:0:ufs::
/dev/ra2b::sw:0:0:ufs::
2. add the following line in /sys/conf/HOSTNAME
config vmunix root on ra0a swap on ra0b and ra1b \
and ra2b dumps on ra0b
3. rebuild kernel
4. reboot
Note: On step (3) be sure to copy the new kernel to /vmunix
Neglecting this little detail was the cause of all my earlier woes
(ie., the "no such device" errors).
Note: On step (1) file-system types other than "ufs" may work
but I did not experiment with any. One wizard suggested that *some*
PD software may prefer the string "swap" in this field.
Note: On step (4) the "swapon -a" command found in /etc/rc
performs the addition of secondary swap at boot time according to
/etc/fstab and echoes this success or failure of this action to the
console.
Since swap space is NOT "mounted" like an ordinary Ultrix
filesystem, it does NOT show up under the "df" command. The "pstat -s"
command can be used to verify a successful configuration.
Thanks to *all* for the help and assistance.
- Joe
--
bush at evax.arl.utexas.edu Vax Systems Manager
(817) 273 - 3333 CSE Dept. UT-Arlington
Office Rm 221 EB2 403 South Cooper
P.O. Box 19015 Arlington, Texas 76019
More information about the Comp.unix.ultrix
mailing list