autoconfigure vpr on vax
Michael Enkelis
michaele at vice.ICO.TEK.COM
Sat Aug 26 03:10:59 AEST 1989
Help!
I am trying to get a versatec device driver built for 4.3.
All goes well in the compile/link steps, but during bootup
in the autoconfigure i get the following message when trying
to configure the vp.
machine check 8: unalgn ioref
params ffff3e,0 pc 80030f65 psl 4 mcesr 0
panic: mchk
dumping to dev b01, offset 0
dump succeeded
The board i have is a Versatec controller model 121, factory strapping.
If i configure my system for a lp, everything autoconfigures fine,
which makes me think that the board is ok since i tried two other boards
with the same results.
This is my config file.
#
# VAX 730
#
machine vax
cpu "VAX730"
ident ENKY
timezone 8 dst
maxusers 8
options INET
options NS
options QUOTA
config vmunix root on rb0
controller uba0 at nexus ?
controller idc0 at uba0 csr 0175606 vector idcintr
disk rb0 at idc0 drive 0
disk rb1 at idc0 drive 1
disk rb2 at idc0 drive 2
controller sc0 at uba? csr 0176700 vector upintr
disk up0 at sc0 drive 0
disk up1 at sc0 drive 1
controller zs0 at uba? csr 0172520 vector tsintr
device ts0 at zs0 drive 0
device dmf0 at uba? csr 0160340 flags 0xfc
vector dmfsrint dmfsxint dmfdaint dmfdbint dmfrint dmfxint dmflint
#Select ONE, but not BOTH.
device vp0 at uba? csr 0177500 vector vpintr
#device lp0 at uba? csr 0177514 vector lpintr
pseudo-device sl
pseudo-device pty
pseudo-device loop
pseudo-device ether
#
The version of /sys/vaxuba/vp.c is "vp.c 7.1 (Berkeley) 6/5/86"
Michael Enkelis
michaele at enky.UUCP
--
_ _ _ __
' ) ) ) / /) / ` / /) Michael Enkelis
/ / / o _. /_ __. _ // /-- __ /_ _ // o _ tektronix!vice!michaele
/ ' (_(_(__/ /_(_(_(<_(/_ (___, /) )_/ <_(<_(/_(_/_)_ (503) 627-4099
More information about the Comp.unix.wizards
mailing list