But I don't wanna do non-blocking I/O...

[John Chambers]

Subject: But I don't wanna do non-blocking I/O...
Newsgroup: comp.unix.wizards

Well, here's a little puzzle that has me stumped; maybe 
someone out ther can tell me what an idiot I've been for
overlooking ______________  (fill in the blank).

What I've got is an application that I'm trying to port
from BSD to SYS/V (ESIX, actually, 5.3 on a 386).  The
application does stuff (which you don't want to know
about ;-) via a serial port, and it normally runs with
the port in raw mode (-icanon, of course).  Sometimes,
it needs to put the port back into a cooded state and
start up a shell to talk to whatever is on the other
side of the port.  The shell starts up, but the port
is still in some sort of half-baked mode that does
non-blocking I/O.  When the shell reads, it gets eof
immediately and exits.  Durned if I can puzzle out why.

I've added code to dump the status of the struct termio
just before the ioctl is done, and it says:
	File 0:    cflag=004275
	File 0:    iflag=006446
	File 0:    lflag=000073
	File 0:    oflag=014005
I've also had it invoke a shell of my own for which I
have the source so I can make it do an ioctl and show
the result, and it gives exactly the same numbers as
above.  According to the termio(7) manual 'page', the
above lflag bits include the 02 bit, which is ICANON,
so the driver should be assembling input into lines,
and not returning anything until it gets an eol char.
But fgets(buf,n,stdin) returns EOF immediately.

It appears there is some way of doing non-blocking I/O
on Sys/V which is unknown to me (and which I can't find
in TFM), but which is known to this program.  I've tried
grepping for all the likely suspects.  There are no calls
of fcntl.  The only calls of ioctl are the ones that set
raw mode initially and the above cooked mode just before
calling a shell.  The open() does include F_NDELAY, but
this is supposed to apply only to the open; it shouldn't
set non-blocking I/O permanently for the file (I hope ;-).
The string "NBIO" does not occur in the code, in upper 
or lower case.

An especially curious aspect is that this code starts
shells successfully on BSD and Ultrix systems, and also
on a SYS/V.2 system that I tried it on.  The non-blocking
I/O doesn't happen there, only on 5.3.

Does anyone know how else one might enable non-blocking
I/O on a Sys/V.3 serial port?  Where might I look in the
manual that I haven't mentioned above?  And how should I
suppress non-blocking I/O?

[Non-blocking I/O certainly isn't one of the more-portable
or better-documented parts of Unix. ;-]

-- 
Uucp: ...!{harvard.edu,ima.com,mit-eddie.edu}!minya!jc (John Chambers)
Home: 1-617-484-6393
Work: 1-508-952-3274
Cute-Saying: It's never to late to have a happy childhood.