Xenix Drivers for AT&T IPC-900 Ports Board, and Wangtech Tape.

[Tillman Basien]

pbye at ub.d.umn.edu (peter bye) writes:

>Does anyone know where I may obtain (preferably free) drivers for an AT&T
>IPC-900 ports card (CTC) and a Wangtek 125MB tape drive under SCO Xenix.
>Thanks in advance!
Wanktek 125MB is includet in SCO XENIX 2.3.2.
Please look in the release notes page A 30.
Use mkdev tape and enter baseport 0x338 (if you has not changed it), dma
cancal 1 Interrup 5 and type W.
Then, after you has generated a new kernel, boot it with reboot or anyting
else.
In the startup message text, after rebooting you must see the tape. Then insert
a tape and enter the command tape reset. Please check the file /etc/default/tape

		device = /dev/xct0

IPC-900:
	Did you checked the file /usr/sys/io/sioconf.c. Is there no entry for
	this board? Sometimes there is a conflict, then you must edit the
	file and remove all not nessery lines.

This was Tillmann, Stuttgart
-- 
					             basien at PEM-Stuttgart.de
Dipl.-Ing. Tillmann A. Basien           PEM Programmentwicklungsgesellschaft
Vaihinger Str.49, PostBox 810165                      fuer Microcomputer mbH
FRG 7000 Stuttgart 80             voice: +49-711-713045  fax: +49-711-713047
-- 
					             basien at PEM-Stuttgart.de
Dipl.-Ing. Tillmann A. Basien           PEM Programmentwicklungsgesellschaft
Vaihinger Str.49, PostBox 810165                      fuer Microcomputer mbH
FRG 7000 Stuttgart 80             voice: +49-711-713045  fax: +49-711-713047