VPIX comm port problem

[Bill Irwin]

mel at fleet.UUCP (mel) writes:

: I cannot get the comm port to run under vpix. The problem has something to
: do with ownership or permissions of my /dev/ttyF07 (modem port) on my
: Computone ALC card."uucp" is the owner/group of the port.  It seems that
: every time uucp is run the permissions & ownership change to those needed
: by uucp, but then VPIX can't acces that port on bootup.

The only thing I found had to be done on our system (386 with
Digiboard & SCO XENIX 2.3.3) was to make sure the port that COMM1
was mapped to in VP/ix was disabled before VP/ix was booted.

I don't recall the error message given by VP/ix if the port was
enabled, but disabling the port solved it.

: Mel Shear
: !rex!fleet!mel
-- 
Bill Irwin    -       The Westrheim Group     -    Vancouver, BC, Canada
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
uunet!van-bc!twg!bill     (604) 431-9600 (voice) |     Your Computer  
bill at twg.bc.ca            (604) 430-4329 (fax)   |    Systems Partner