SCO Xenix on an IBM PS/2 Model 70
Nirad Sharma
exnirad at brolga.cc.uq.oz.au
Fri May 31 13:24:56 AEST 1991
jep at pcgbase.UUCP (John E. Phillips) writes:
>Can someone tell me if I need a special version of Xenix to run on
>the IBM PS/2 Model 70, or would a standard Xenix (Not GT) run?
>I have 4MB of ram and an 80mb Hard disk.
I am running Xenix 2.3.2PS on a PS/2 Model 80. Note the PS in the version
number. I assume that this catersfor any MCA differences. Otherwise, everything
runs fine (software / MCA hardware). My hardware is :
IBM PS/2 Model 80 + 4Mb on system board
HyperRam 16/32 4Mb
HyperPort 3 Serial + 1 Parallel
Anvil Stallion 12-port Intelligent Serial Controller
Excelan 215T Intelligent Ethernet Card (TCP/IP)
Cipher Streaming Tape Controller
WD Hard disk controller (used to have IBM's but it was too dumb)
2 HDs -> 110 IBM std ESDI
160 Micropolis ESDI
Has been working fine for approx 2 years as an Oracle db engine / app.
--
Nirad Sharma (exnirad at brolga.cc.uq.oz.au) Phone : (+61 7) 365 7575
Systems Programmer Fax : (+61 7) 870 5080
Continuing Education Unit
The University of Queensland. QLD 4072
More information about the Comp.unix.xenix.sco
mailing list