COM3/COM4 under Xenix

[Steve Souza @telesoft]

Bob,

I posted the article below, but didn't get any response.  Perhaps
it will be of some use to you.  If anybody has any suggestions
they're holding out with (;-), I'd still appreciate the info.

Thanks again,
Steve
-------------------------------------------------------------------
Hi Folks,

We've recently developed a serial mouse driver for a Unisys PC
running SCO Xenix.  Since moving the driver from OS version 2.2(.3?)
to 2.3, the message:

serial: WARNING: interrupt vector collision

has begun to appear.  The mouse plugs into either COM1 or COM2, 
interrupting on vector levels 4 and 3, respectively.  We remove the 
vector level associated with the mouse from the standard serial driver 
(sio), so the resulting configuration lines look as follows:

sio      3  0577 104    sio  0   0   5    1   7    4     33    34  0   
mse      1  0537 104    mse  0   0  27    1   5    3     0     0   0   

I don't see a collision here.  Is this OS confusion, or are we doing 
something weird?  Both the mouse and the other serial port (connected to 
a terminal) work fine.

Appreciate any suggestions!

Steve Souza		Optigraphics Corp., San Diego, CA
ucsd!scubed!opti!souza	(619)292-6060