SCO Xenix 2.3.1 and Adaptec 1542B

[neese at adaptex.UUCP]

>/* ---------- "SCO Xenix 2.3.1 and Adaptec 1542B" ---------- */
>We are having problems installing an Adaptec 1542B SCSI controller
>on '386 AT box running SCO Xenix 2.3.1.  We're trying to run it with a
>SCSI 700Mb 8000 series Maxtor HD, a SCSI tape drive, an MFM controler with
>a two hard drives attached (one not installed in Phoenix BIOS CMOS),
>and assorted other cards and periphs (VGA, 16 and 32 bit RAM, serial/paralel,
>mutli-port serial, no floppies).  The Adaptec tries to find target 0 or
>something and fails (we've tried it with both and either of the tape,
>and the 700M HD on the bus).  We got no documentation with the Adaptec,
>but we had a FAX of some sort of instalation card.  Our worse problem is
>however is that we've just found that SCO's SCSI driver is just a stub.
>Does SCO or Adaptec have a real SCSI driver?
>
>Any help would be appreciated, we would like to get the new HD and tape
>up and running as soon as possible.

You need SCO XENIX V2.3.2GT to get the 154x to run.  This is the only version
of XENIX that supports the 154x.

			Roy Neese
			Adaptec Senior SCSI Applications Engineer
			UUCP @  uunet!swbatl!texbell!
				  {nominil,merch,cpe,mlite}!adaptex!neese