Diagnostics Error with a AT&T 7300

[Pete Holsberg]

In article <19615 at adm.BRL.MIL> sanford at ssurf writes:
=Hi Everyone,
=   I have a PC7300 that dosen't want to boot from the hard drive. It had been
=running fine for about 1.5 years and all of a sudden this happened. I have
=booted it fine from the floppy drive and I can run diagnostics from the floppy.
=All of the diagnostics run fine except the hard drive where is says 
=
=ERROR Can't Recal: 

Manual says,

"This problem can be caused by either a bad logic board or a bad hard disk
drive.
		1.  Replace the logic board.
		2.  If a new logic board does not correct the problem, replace the
		    hard disk drive."

I hope this helps, but I don't see how it can.  :-(  Personally, I'd try
swapping out the HD drive first.
-- 
Pete Holsberg, Mercer County Community College, Trenton, NJ 08690